Data Links Procedures; Manually Setting Data Links - Omron CS1W-CLK12-V1 Operation Manual

Data Links Procedures

2-1 Data Links Procedures
2-1-1

Manually Setting Data Links

1,2,3...
32
When the data link mode is set for manual data link table creation, the data
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
1. Install and wire the Units.
Contents
• Mount the Units to the
PLCs.
• Wire the Network.
2. Prepare for communications.
Contents
• Set the unit number.
(See note.)
• Set the node address.
(See note.)
Note When using Controller Link Units in duplex operation, set the same unit num-
ber and node address for both Units.
3. Turn ON the power to the PLC.
Contents
Turn ON the power to
the PLC.
4. Connect the Programming Device.
Contents
Connect the Program-
ming Device.
Note A Programming
Console can be
used if there is
no duplex opera-
tion.
5. Make duplex settings for Communications Units. Create I/O tables.
Contents
Make duplex settings for
Communications Units
(in PLC Setup).
Input the I/O tables.
(See note.)
Note When I/O tables for configurations with Communications Units used in duplex
operation are created, the Unit with the lower slot number will be designated
as the active Unit and the Unit with the higher slot number will be designated
as the standby Unit. To reverse this designation, edit the I/O tables offline and
transfer them to the PLC.
Method
--- All nodes
--- All nodes
Method
Use the front rotary All nodes
switches.
Use the front rotary All nodes
switches.
Method
--- All nodes
Method
Use the special connec- All nodes
tion cable.
Method
Use the Programming Duplex nodes
Device.
Use the SYSMAC Sup- All nodes
port Software or Pro-
gramming Console.
Section 2-1
Nodes Page
50
54
Nodes Page
67, 71
68, 72
Nodes Page
---
Nodes Page
22
Nodes Page
173
173