Cabletron Systems 2E43-51 User Manual page 30

Chapter 3: Installation
Rack Mounting the 2E43-51
Proceed as follows to install the 2E43-51 into a 19-inch rack.
1. Remove and discard the four cover screws (two from each side)
located along the front edges of each side of the 2E43-51.
2. Locate the four 6-32 x 3/8-inch flathead cover replacement screws in
the rackmount kit. Use these screws to attach the rackmount brackets
to the 2E43-51 as shown in
E3
E1
2E43-51
RESET
Figure 3-3 Installing the Rackmount Brackets
3. With the mounting brackets installed, position the 2E43-51 between
the vertical frame members of the 19-inch rack and fasten it securely
with user supplied mounting screws as shown in
E3 E4
E1 E2
2E43-51 RESET
3-6
Rackmount Brackets (2)
LINK 1 12 LINK 1
E4
E2
ENET 3
12
LINK 1 LINK 1
PWR
CPU
ENET 1
COM
19-Inch Rack
12
LINK 1 LINK 1
ENET 3
LINK 1 12 LINK 1
PWR
CPU
ENET 1
COM
Screws (4)
Figure 3-4 Installing the 2E43-51 in a Rack
Figure 3-3.
12
ENET 4
12
ENET 2
5
Screws (4)
12
ENET 4
12
ENET 2
5
2E43-51/2E43-51R User's Guide
6
2251-04
Figure 3-4.
6
2251-03