Setting The Fe-100Tx Advertised Ability; Flash Download Screen - Cabletron Systems 2E43-51 User Manual

Chapter 5: Local Management
3. Use the arrow keys to highlight the SAVE command. Press ENTER.
The message "SAVED OK" displays and Local Management saves
the changes to memory. The selected mode is displayed in both the
Desired Operational Mode field and the Current Operational Mode
field.

5.14.2.2 Setting the FE-100TX Advertised Ability

In normal operation, a port (5 or 6) with an FE-100TX auto-negotiates to
the highest speed possible. Under some circumstances, the Network
Administrator may want the port to advertise only some of the available
modes. The Advertised Ability field provides the capability to set those
modes. This field steps to 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). To set the advertised
ability, proceed as follows:
1. Use the arrow keys to highlight the Advertised Ability field.
2. Use the SPACE bar to select the desired mode.
3. Use the arrow keys to move to the Enable/Disable field at the right of
the desired mode and use the SPACE bar to select Enabled or
Disabled. Press ENTER.
4. Continue this process until you have completed enabling or disabling
the advertised modes.
5. Use the arrow keys to highlight the SAVE command. Press ENTER.
The message "SAVED OK" displays and Local Management saves
the changes to memory.
5.15

FLASH DOWNLOAD SCREEN

The Flash Download screen, shown in
upgrade the device with a different operating image.
The user may also force the download of an image by changing
NOTE
the position of Switch 6 located inside the device. For details
about setting the switch, refer to
5-50
Figure 5-22, allows the user to
Section C.2.1.
2E43-51/2E43-51R User's Guide