Table of Contents
Advertisement
Coverplate
5
2.
Remove the screw from the rear standoff. Save the screw.
When installing an FE-100FX or FE-100F3 module into the
!
2E43-51, remove the rubber plug on the module before
CAUTION
proceeding.
3.
See
Figure
allow room for the Fast Ethernet Interface Modules to be aligned over
the connector.
In the following step, take care when inserting the Fast Ethernet
!
Interface Module into the Motherboard Connector, so that the
CAUTION
pins do not bend. Otherwise, the Fast Ethernet Interface Board
and the Motherboard could be damaged.
2E43-51/2E43-51R User's Guide
Installing Optional Fast Ethernet Interface Modules
6
Figure C-4 Coverplate Removal
C-5. Gently pull the faceplate of the 2E43-51 forward to
Rear
Standoff
Front
Standoffs
C-9
2251-38
Advertisement
Table of Contents
