Repeater Level Security Configuration - Cabletron Systems 2E43-51 User Manual

Chapter 5: Local Management
PORT LEVEL SECURITY CONFIGURATION
Used to set the security for each port of a connector, individually. For
details, refer to
5.19

REPEATER LEVEL SECURITY CONFIGURATION

The Repeater Level Security Configuration screen,
set the state of security for all ports on a connector. A connector can be set
to receive all frames (NonSecure state), lock on the source address of the
next frame received (LockOnNext), or lock on the source address of the
last frame received (LockedOnAddr). When either of the last two options
are set, the switch can be set to receive or not receive frames and to send
or not send traps when an intruder is detected.
To access the Repeater Level Security Configuration screen, use the arrow
keys to highlight the REPEATER LEVEL SECURITY
CONFIGURATION menu item on the Repeater Configuration Menu
screen and press ENTER. The Repeater Level Security Configuration
screen displays.
Module Type: 2E43-51
Interface
1
2
3
4
SAVE
Figure 5-26 Repeater Level Security Configuration Screen
5-62
Section 5.20.
2E43-51 LOCAL MANAGEMENT
Repeater Level Security Configuration
State Lock/Learn
[Secure] [LockOnNext]
[Secure] [LockOnNext]
[Secure] [LockedOnAddr]
[NonSecure]
Figure
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Action On Intruder
[DisablePort] [SendTrap]
[DisablePort] [SendTrap]
[DisablePort] [SendTrap]
EXIT
2E43-51/2E43-51R User's Guide
5-26, is used to
XX.XX.XX
RETURN
2251_112