Special Commands - Cabletron Systems 2E43-51 User Manual

Chapter 5: Local Management
atm_stp_state:
The atm_stp_state command is only available if an
NOTE
HSIM-A6DP is installed in the device (e.g.,2E43-51). This
command allows the user to enable, disable, or check the
current status of the Spanning Tree Algorithm on all ATM
interfaces.
Syntax:
Description:
Options:
Example:

5.26.2 Special Commands

done, quit, exit:
Syntax:
Description:
Options:
5-94
atm_stp_state [STATE]
The atm_stp_state command allows the user to
enable, disable, or check the status of the
Spanning Tree Algorithm on all ATM
interfaces. The user must specify the STATE
option as enable, disable, or status. The STATE
field is mandatory.
enable, disable, status
-> atm_stp_state status
Atm Stp is Enabled
-> atm_stp_state disable
-> atm_stp_state enable
done, quit, or exit
The done, quit, or exit command enables the
user to exit from Network Tools and return to
the Main Menu screen.
Not Applicable
2E43-51/2E43-51R User's Guide
2314-79