Clearing Nvram - Cabletron Systems 2E43-51 User Manual

7. Use the SPACE bar or BACKSPACE to step through the available
settings until the operation you require appears.
available settings and their corresponding applications.
Setting
[LM]
[UPS]
8. Press ENTER to accept the application.
9. Use the arrow keys to highlight the SAVE command at the bottom of
the screen, then press the ENTER key.
10. When the message "SAVED OK" displays, the edits are saved.

5.7.11 Clearing NVRAM

Clearing NVRAM will result in the loss of all user-entered
!
parameters. Do not proceed unless this procedure is
CAUTION
completely understood.
Clearing NVRAM allows the user to clear all user-entered parameters,
such as, the IP address and Community Names from NVRAM.
Clear NVRAM as follows:
1. Use the arrow keys to highlight the Clear NVRAM field.
2. Use the SPACE bar to toggle the field to YES.
3. Use the arrow keys to highlight SAVE at the bottom of the screen.
4. Press ENTER. The warning screen shown in
2E43-51/2E43-51R User's Guide
Table 5-3 COM Port Application Settings
Application
Local Management Session
APC Power Supply SNMP Proxy
General Configuration Screen
Table 5-3
Figure 5-14
lists the
displays.
5-29