Prop Shaft Removal / Installation; Prop Shaft Removal / Installation (4-Seat) - Polaris RZR PRO XP 2020 Service Manual

FINAL DRIVE
TORQUE
Front Caliper Mounting Bolts:
33 ft-lbs (45 Nm)
TORQUE
Front Bumper Mounting Fasteners:
30 ft-lbs (40 Nm)
TORQUE
Front Bumper Cover Mounting Fasteners:
7 ft-lbs (10 Nm)
TORQUE
Wheel Nuts:
120 ft-lbs (163 Nm)
PROP SHAFT REMOVAL /
INSTALLATION (4-SEAT)
REMOVAL
1. If removing the front prop shaft, Locate the prop
q
shaft roll pin and use the Roll Pin Removal Tool to
remove the roll pin. Discard roll pin. Push the front
prop shaft rearward to remove it from the front
gearcase input shaft.
Roll Pin Removal Tool:
2872608
NOTICE
Right front wheel can be removed to gain better access
to the prop shaft roll pin.
8.24
2. Remove the fasteners
and rear skid plates.
3. Remove the four fasteners
shaft to the transmission coupler. Discard the
fasteners. Move the prop shaft off the coupler
towards the outside of the vehicle.
IMPORTANT
The coupler fasteners have patch lock on the threads
and must be replaced any time they are removed.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
w
retaining the front, middle,
e
retaining the rear prop
© Copyright Polaris Industries Inc.