ENGINE / COOLING SYSTEM
o
14. Install the eleven M6
crankcase bolts. Tighten all bolts lightly by hand.
15. Torque the upper crankcase bolts in sequence to
specification. Repeat the sequence to verify final
torque.
TORQUE
Upper Crankcase Bolts:
M8 Bolts:
26 ft-lb (35 Nm)
M6 Bolts:
9 ft-lb (12 Nm)
16. Rotate the engine so the cylinder is facing down.
17. Install a new seal on the oil pump.
18. Lift the oil pump drive chain and install the oil pump.
3.88
i
and two M8
upper
s
19. Install dowel pins
into oil pump mounting holes.
d
20. Install the three bolts
crankcase. Torque mounting bolts to specification.
TORQUE
Oil Pump Mounting Bolts:
7 ft-lbs (10 Nm)
21. Reinstall oil pump pick-up
g
to specification.
TORQUE
Oil Pump Pick-Up Retaining Screw:
7 ft-lb (10 Nm)
22. Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and any
oil.
NOTICE
Gasket surfaces must be DRY and oil free. Use care
upon assembly to keep oil away.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
that retain oil pump to the
f
. Torque mounting screw
© Copyright Polaris Industries Inc.