Polaris RZR PRO XP 2020 Service Manual page 411

31. Remove negative spring assembly, bearing
assembly, and bumper.
32. With the shaft assembly placed in clamp block and
secured in vise, apply a sufficient amount of heat to
the eyelet with a propane torch to remove the eyelet
with the correct body cap socket.
33. Use a wire brush, heat, and a pick to remove any
Loctite residue left in the eyelet and shaft threads.
Clean thoroughly with contact cleaner and lint-free
towel.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
STEERING / SUSPENSION
34. Apply Loctite primer 7649 to eyelet threads
over-spray off any external surface.
35. Remove all seals and o-rings from bearing assembly.
NOTICE
If the DU bearing needs replacement, replace the
complete bearing assembly.
36. Clean all surfaces of the bearing housing and cinch
ring.
q
. Wipe
9
9.37