Polaris RZR PRO XP 2020 Service Manual page 398

STEERING / SUSPENSION
8. Remove the rear wheel hub and brake disc assembly.
9. Remove the four remaining bolts
rear bearing carrier to trailing arm. Discard the nuts.
10. Remove the bearing carrier from the rear drive shaft
and trailing arm.
11. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion. Replace bearing if moisture, dirt, corrosion,
or roughness is evident.
12. Remove the four clips
retainers to the trailing arm.
13. Remove the lower stabilizer bar linkage fastener
Discard the nut.
14. Support trailing arm with suitable jack stand or
support.
9.24
i
that attach the
o
that secure the brake line
15. Remove the lower shock bolt
16. Remove the front trailing arm bolt
17. Remove trailing arm from vehicle. Visually inspect
trailing arm, bushings, o-rings and spherical bearing
for wear.
18. Replace trailing arm if physically damaged.
INSTALLATION
1. Reverse removal procedure to reinstall rear trailing
arm.
a
Use new fastener nuts upon installation of the rear
.
trailing arm and bearing carrier.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
s
. Discard the nut.
d
. Discard the nut.
NOTICE
© Copyright Polaris Industries Inc.