Front Engine Mount Isolator Replacement - Polaris RZR PRO XP 2020 Service Manual

17. Install clutch intake duct, and tighten two worm
clamps to specification.
TORQUE
Worm Clamps
35 in-lbs (4 Nm)
18. Connect the battery. Torque fasteners to
specification.
TORQUE
Battery Fasteners:
60 in-lbs (7 Nm)
FRONT ENGINE MOUNT ISOLATOR
REPLACEMENT
1. Remove the rear skid plate fasteners
the skid plate from the vehicle.
2. Using a commercially available transmission lift or
pump jack, lift the front engine mount to take the
weight off the isolators.
q
3. Remove the fasteners retaining the isolator
mounts to the frame.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
4. Remove the isolator bolt
5. Install new isolator and bolt. Torque fastener to
specification.
6. Lower the lift or jack and align the isolator tang with
the holes in the frame. Install isolator to frame
fasteners. Torque fasteners to specification.
7. Install rear skid pan. Torque fasteners to
specification.
q
and remove
ENGINE / COOLING SYSTEM
w
and remove the isolator.
TORQUE
Engine Mount Isolator Bolts:
40 ft-lbs (54 Nm)
Engine Mount Nuts:
22 ft-lb (30 Nm)
Skid Pan Fasteners:
8 ft-lbs (11 Nm)
3
3.43