Inner Plunging Joint / Boot Replacement - Polaris RZR PRO XP 2020 Service Manual

FINAL DRIVE
10. Install and tighten the large clamp
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
CV Boot Clamp Pliers: 8700226
11. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize in
the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
12. Install and tighten the small clamp
using the appropriate clamp tool.
8.18
e
using the
or
r
on the boot
INNER PLUNGING JOINT / BOOT
REPLACEMENT
NOTICE
This procedure applies to the front drive axles only.
1. Use a side cutters to cut and discard the boot clamps
q
.
2. Remove the large end of the boot from the plunging
joint and slide the boot down the shaft.
3. Remove the large circlip near the boot end of the
plunging joint.
4. Clean the grease from the face of the joint.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.