Rear Brake Service; Brake Caliper / Pad Removal - Polaris RZR PRO XP 2020 Service Manual

BRAKE SYSTEM

REAR BRAKE SERVICE

BRAKE CALIPER / PAD REMOVAL

1. Elevate and support rear of vehicle.
CAUTION
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Remove the rear wheel.
3. Loosen pad adjuster screw 2-3 turns.
4. Remove the lower radius rod outer mounting bolt
nut and washer from the bearing carrier. Swing radius
rod down. Discard the nut.
10.28
5. Remove the two caliper mounting bolts
caliper off the brake disc.
When removing caliper, be careful not to damage brake
line. Support caliper to avoid kinking or bending brake
6. Push caliper piston into the caliper bore slowly using
a C-clamp or locking pliers with pads installed.
q
,
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
NOTICE
line.
NOTICE
reservoir as required.
© Copyright Polaris Industries Inc.
w
and lift