Polaris RZR PRO XP 2020 Service Manual page 387

5. Torque the four mount bracket nuts
specification.
TORQUE
Power Steering Unit Mount Bracket Nuts:
18 ft-lb (24 Nm)
6. Proceed to Upper Steering Shaft Installation page
7. Vehicles equipped with Dynamix suspension having a
steering shaft, EPS unit, steering rack, or tie rod
removed/adjusted/disconnected MUST have Steering
Angle Sensor Centering procedure performed once
everything is reinstalled. Refer to Steering Angle
Sensor Centering (Dynamix) page 12.17.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
UPPER STEERING SHAFT
y
to
INSTALLATION
If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned
Striking the steering wheel or steering shaft while
installed in the vehicle can permanently damage the
EPS unit and cause a Power Steering Fault.
Be sure upper steering shaft hardware is positioned
1. Install the upper steering shaft and align the skip-
tooth spline
the opening
.
2. Install the steering column asm and torque fasteners
to specification.
3. Install the tilt shock and torque fastener to
specification.
STEERING / SUSPENSION
NOTICE
on the power steering stub shaft.
CAUTION
NOTICE
correctly.
q
on the power steering stub shaft with
w
in the upper steering shaft.
TORQUE
Steering Column Asm Fasteners:
40 ft-lb (54 Nm)
TORQUE
Tilt Shock Fastener:
7 ft-lb (10 Nm)
9
9.13