Engine Assembly - Top End; Cylinder Head Assembly - Polaris RZR PRO XP 2020 Service Manual

ENGINE / COOLING SYSTEM

ENGINE ASSEMBLY - TOP END

CYLINDER HEAD ASSEMBLY

NOTICE
Assemble the valves one at a time to maintain proper
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.
1. Apply engine oil to valve guides and seats.
2. Coat valve stem with Premium Starter Grease
(2871460).
q
3. Install the valve in the cylinder head, through the
guide.
4. Carefully install a new valve seal / seat
valve guide with a rotating motion. Push firmly until
seated in retaining groove and square with the guide.
NOTICE
Valve seals should be installed AFTER the valves are in
the head to avoid valve seal damage.
e
5. Dip the valve spring
engine oil.
3.92
order.
WARNING
w
on the
r
and retainer in clean
6. Install the valve spring with widely spaced coils
the top and tightly spaced coils
the cylinder head.
NOTICE
Valve springs to be installed with paint mark facing up.
7. Place the valve retainer on the spring.
8. Compress the valve spring by hand using valve
spring compressor adapter (PV-43513-A). Compress
spring only enough to allow split keeper installation.
NOTICE
To prevent damage to the valve seals, do not compress
the valve spring more than necessary to install the
keepers.
t
9. Install split keepers
10. Repeat this procedure for remaining valves.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
u
facing down toward
with gap even on both sides.
© Copyright Polaris Industries Inc.
y
on