Polaris RZR PRO XP 2020 Service Manual page 362

FINAL DRIVE
4. Inspect armature plate
pattern. There should be two distinct wear bands
If only one band of wear is present (or if there is wear
between the two bands), inspect the coil area as
indicated in Step 5. A wear band with an interrupted
wear mark may indicate a warped plate, which may
cause intermittent operation.
5. Check to make sure the coil
y
shaped insert that is pressed into the gearcase
u
cover . The top of the coil should be seated below
the U-shaped insert. The U-shaped insert controls the
pole gap. If the top of the coil is above the surface of
the U-shaped insert it raises the armature plate,
thereby increasing pole gap. If the pole gap increases
the coil will not be strong enough to engage the AWD
system. If this is found, replace the cover plate
assembly.
8.34
e
for a consistent wear
t
is seated in the U-
6. Inspect the roller surface on the inside of the ring gear
r
. for gouging/rough spots.
7. Inspect the roll cage
excessive wear. If damaged, replace the roll cage
assembly.
8. Inspect the rollers
rollers must slide up, down, in and out freely within
the roll cage sliding surfaces and H-springs.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
o
assembly for cracks or
a
for nicks and scratches. The
© Copyright Polaris Industries Inc.