Suspension Lubrication; Spring Adjustment - Polaris RZR PRO XP 2020 Service Manual

MAINTENANCE

SUSPENSION LUBRICATION

Refer to Grease Lubrication Points page
suspension lubrication.
NOTICE
There are no grease fittings on the front control arm
pivot points or the rear trailing arms.

SPRING ADJUSTMENT

The front and rear shocks have a ride height adjustment.
Suspension springs may be adjusted to suit different
riding conditions or vehicle payloads.
Uneven adjustment may cause poor handling of the
vehicle, which could result in serious injury or death.
Always adjust both the left and right spring equally.
The factory setting is appropriate for nearly all riding
conditions. If desired, the spring setting may be adjusted
to maintain vehicle clearance height when carrying
loads.
1. Raise and safely support front or rear of the vehicle
off the ground to allow the suspension to fully extend.
2. Using the shock spanner/spreader tool included in
the vehicle's tool kit, turn the adjustment collar
w
increase or decrease
RZR PRO XP (Walker Evans Shocks)
RZR PRO XP (Fox Shocks)
2.52
for
WARNING
e
ride height.
SPRING ADJUSTMENT - FACTORY SETTING (APPROX.)
MODEL
Shock Spanner / Clutch Spreader Tool:
Polaris does not recommend increasing the spring
adjustment by more than one inch (25.4 mm) over the
factory setting
stability. Always return the spring preload to the factory
setting after the load is removed from the vehicle.
q
to
FRONT
2.62" (6.65 cm)
2.79" (7.09 cm)
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
2878925
NOTE
r
as it may negatively impact vehicle
REAR
8.29" (21.06 cm)
9.25" ( 23.49 cm)
© Copyright Polaris Industries Inc.