Wheel Toe Alignment Inspection - Polaris RZR PRO XP 2020 Service Manual

WHEEL TOE ALIGNMENT INSPECTION

1. Place machine on a smooth level surface and set
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10" (25.4 cm) from the floor or as close
to the hub/axle center line as possible
NOTICE
It is important the height of both marks be equally
positioned to get an accurate measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
q
.
5. Measure the distance between the marks and record.
Call this measurement
from measurement
means the measurement at the front of the tire
wider than the measurement at the rear
just the opposite.
w
.
1/4" (6.35 mm) toe-in – 1/4" (6.35 mm) toe-out
MAINTENANCE
e
. Subtract measurement
w
, this is the vehicle toe. Toe-out
e
. Toe-in is
MEASUREMENT
Wheel Toe:
2
e
w
is
2.49