Cps Replacement - Polaris RZR PRO XP 2020 Service Manual

ENGINE ELECTRICAL

CPS REPLACEMENT

1. If not done already; disconnect the CPS harness
connector (see Chapter 4 – CPS Test page 4.7).
2. Using an 8mm socket, remove the CPS retaining bolt
q
and remove the sensor
3. Unclip the wire harness retainer
CPS harness from the retainer to allow replacement.
4. Install new sensor using a light coating of oil on the
O-ring to aid installation.
5. Torque the CPS retaining bolt to specification.
TORQUE
CPS Retaining Bolt:
9 ft-lbs (12 N·m)
4.8
w
from the stator cover.
e
and remove the
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.