Vent Line Termination Fitting - Polaris RZR PRO XP 2020 Service Manual

EFI / FUEL SYSTEM
2. Retain vent line to the purge line with a zip tie
3. Route vent line into the carbon canister
t
4. Route vent line from the carbon canister to the
y
canister filter .
u
5. Route vent line up from the canister filter and
attach to two retaining clips
5.20
e
.
r
.
i
.
6. Route vent line back along the left shock support tube
and attach to the fitting in the frame

VENT LINE TERMINATION FITTING

This fitting should be inspected and tested using a Mity
Vac™ to ensure proper venting. Connect the Mity Vac to
the fitting and give it 5 pumps. The gauge should return
to 0 immediately or there is an obstruction.
NOTICE
If the vent line fitting is removed from the frame, it must
be replaced. The ears on the clip (arrows) will not hold
properly once it is removed.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
o
.
© Copyright Polaris Industries Inc.