Polaris RZR PRO XP 2020 Service Manual page 338

FINAL DRIVE
7. Install the rear brake caliper assembly and new bolts
t
. Torque to specification.
TORQUE
Rear Caliper Mounting Bolts:
33 ft-lbs (45 Nm)
8. Install lower radius rod. Torque fastener to
specification.
TORQUE
Outer Radius Rod Fastener:
52 ft-lbs (70 Nm) + 90°
9. Install rear brake line guide
Torque fasteners to specification.
TORQUE
Brake Line Guide Fasteners:
7 ft-lbs (10 Nm)
8.10
u y
and two fasteners .
10. Torque wheel hub nut to specification and install a
i
new cotter pin . Tighten nut slightly if necessary to
align cotter pin holes.
TORQUE
Hub Castle Nut:
180 ft-lbs (244 Nm)
11. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
120 ft-lbs (163 Nm)
12. Allow 4 hours for Loctite® 680 to cure before vehicle
use.
CAUTION
Loctite® MUST cure for at least 4 hours before using
the vehicle.
13. Rotate wheel and check for smooth operation. Bend
both ends of cotter pin around end of spindle in
different directions.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.