Remote Start/Stop - EBARA ESA300W Instruction Manual

7.2.2 REMOTE Start/Stop

a) START
Enter the external "MP" start signal input from the control connector. The MP
starts.
In the automatic BP operating mode, the BP can be started/stopped
automatically.
When the BP is operated under external start signal input, apply the external
BP start signal to the control connector.
The current is indicated on the display during pump operation. For other
status display indications, refer to Table 6.1.
[NOTE] The pump will not start when an ALARM/WARNING has been generated.
When a START signal is entered, "STARTFAIL" will appear on the display.
BP can be started/stopped by the external signal when the DIPswitch set
accordingly.
b) STOP
When ALTERNATE has been selected, interrupt the external MP start signal
and the pump will stop.
When MOMENTARY has been selected, enter the external MP stop signal
and the pump will stop.
*Please refer to the COMMUNICATION SPCIFICATIONS in detail.
(54)
EBARA
CORPORATION