Mitsubishi MOTORS Shogun 2007 Owner's Manual page 281

Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towing
bar, you can change the reversing sensor system between the
standard mode and the towing bar mode. The towing bar mode
changes the system to exclude the area in which the towing bar
is mounted from the detection areas.
Vehicles without towing bar
The detection areas are within approximately 50 cm (A) from
the corner sensors, 150 cm (B) from the back sensors.
Vehicles with towing bar
The detection areas are within approximately 50 cm (A) from
the corner sensors, 150 cm (B) from the back sensors. The non-
detection areas (C) are within approximately 20 cm (D) from
the bumper.
NOTE
● If the rear bumper or the spare wheel garnish has been
exposed to an impact, the corner or back sensors may fail
and prevent the system from functioning properly. We rec-
ommend you to have your vehicle inspection.
● The sensors do not detect objects located in the area
directly below or near the bumper. If the height of an
object is lower than the mounted position of the corner or
back sensors, the sensors may not continue detecting it
even if they detected it initially.
Starting and driving
4
4-79