Mitsubishi MOTORS Shogun 2007 Owner's Manual page 239

To shift from To
The transfer shift lever can be operated while the vehi-
2H 4H
cle is either moving or stationary.
When the vehicle is not in motion, shift the gearshift
2H or
lever to the "N" (Neutral) position before operating the
4H
4HLc
transfer shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, and release the accelerator pedal
4HLc 4H
before operating the transfer shift lever.
4HLc 4LLc Stop the vehicle, depress the clutch pedal to the floor
and operate the transfer shift lever.
Keep depressing the clutch pedal while the 2WD/4WD
4LLc 4HLc
operation indication lamp continues to blink.
NOTE
● Shifting of the lever among "2H" ↔ "4H" ↔ "4HLc" should only be done at speeds below 100 km/h (62 mph).
● When shifting from "2H" to "4H" in cold weather while the vehicle is in motion, the transmission gear may make some noise.
In cold weather, try to shift the gear while the vehicle is stopped.
● When the lever is shifted between "2H" ↔ "4H" or "4H" ↔ "4HLc" while the vehicle is stopped, the 2WD/4WD operation
indication lamp blinks while the selection is in process. Drive slowly and normally after confirming that the lamp is illumi-
nated. Refer to "2WD/4WD operation indication lamp" on page 4-38.
● Do not move the selector lever while the 2WD/4WD operation indication lamp is blinking.
● On vehicles with cruise control, when the lever is shifted among "2H" ↔ "4H" ↔ "4HLc" while the cruise control is acti-
vated, the transfer gear may make some noise.
CAUTION
!
● Do not operate the transfer shift lever while the rear wheels of the vehicle are slipping on snow or ice.
Vehicles with M/T
Procedure
Vehicles with A/T
The transfer shift lever can be operated while the vehi-
cle is either moving or stationary.
When the vehicle is not in motion, shift the selector
lever to the "N" (NEUTRAL) position before operating
the transfer shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, shift the selector lever to the
"D" (DRIVE) position, and release the accelerator
pedal before operating the transfer shift lever.
Stop the vehicle, shift the selector lever to the "N"
(NEUTRAL) position, and operate the transfer shift
lever.
Starting and driving
4
4-37