Mitsubishi MOTORS Shogun 2007 Owner's Manual page 270

Starting and driving
NOTE
● Immediately after reconnection of the battery cable, the
indication lamp will illuminate and the active stability
control function will stop operating. If the vehicle is
driven and the indication lamp goes off, the active sta-
bility control function will again start operating.
If the indication lamp illuminates again or illuminates
even though the battery has not been disconnected, an
insufficient battery voltage or other problems may be the
reason. We recommend you to have your vehicle
inspected.
4
4-68
Active traction control function
The active traction control function maintains traction on slip-
pery road surfaces by automatically controlling the engine out-
put and applying the brakes so the driving wheels are
prevented from spinning.
The active traction control function automatically turns ON
when the ignition switch is turned to the "ON" position.
CAUTION
!
● If the temperature in the braking system increases
excessively due to continuous brake control on a
slippery road surface, a warning buzzer will sound
intermittently to warn the driver. If driving contin-
ues in spite of the buzzer and the temperature in the
braking system increases further, the
lamp will illuminate, the warning buzzer will sound
continuously for approximately 3 seconds, and
active traction control function operation will be
suspended to protect the braking system. (Normal
operation of the vehicle will not be affected.) If the
vehicle is stopped and the
off, the active traction control function will start
operating again.
E00614100041
indication
indication lamp goes