Mitsubishi MOTORS Shogun 2007 Owner's Manual page 215

Retracting and extending the mirrors using the mirror
retractor switch
With the ignition switch in the "ON" or "ACC" position, push
the mirror retractor switch to retract the mirrors. Push it again
to extend the mirrors to their original positions.
After placing the ignition switch in the "LOCK" position, it is
possible to retract and extend the mirrors using the mirror
retractor switch for about 30 seconds.
CAUTION
!
● It is possible to retract and extend the mirrors by
hand. After retracting a mirror using the mirror
retractor switch, however, you should extend it by
using the switch again, not by hand. If you extended
the mirror by hand after retracting it using the
switch, it would not properly lock in position. As a
result, it could move because of the wind or vibra-
tion while you are driving, taking away your rear-
ward visibility.
NOTE
● Be careful not to get your hands trapped while a mirror is
moving.
● If you move a mirror by hand or it moves after hitting a
person or object, you may not be able to return it to its
original position using the mirror retractor switch. If this
happens, push the mirror retractor switch to place the mir-
ror in its retracted position and then push the switch again
to return the mirror to its original position.
● If the battery voltage is low and you start the engine while
extending the mirrors, the mirrors may stop part-way. If
this happens, push the mirror retractor switch to retract the
mirrors and then push the switch again to extend them.
● When freezing has occurred and mirrors fail to operate as
intended, please refrain from repeated pushing of the
retractor switch as this action can result in burn-out of the
mirror motor circuits.
Starting and driving
4
4-13