Mitsubishi MOTORS Shogun 2007 Owner's Manual page 269

Active stability control function indication lamp
Active stability control function indication lamp
Active stability control function OFF indication lamp
The indication lamps should illuminate when the ignition
switch is turned to the "ON" position and should go off after a
few seconds.
If the indication lamps stay on or do not illuminate when the
ignition switch is turned to the "ON" position, we recommend
you to have your vehicle inspected.
indication lamp blinks when the active stability control
E00614000125 function is operating.
indication lamp illuminates when the active stability control
function is deactivated by either of the following operations:
● The ASC OFF switch is pressed to deactivate the system.
● The transfer shift lever is placed in the "4LLc" position.
CAUTION
!
● When
indication lamp blinks, the active stability
control function is operating, which means that the
road is slippery or that your vehicle's wheels are
spinning excessively. If this happens, drive slower
with less accelerator input.
● If a fault occurs in the device, the ABS warning
lamp or
warning. Park your vehicle in a safe place and stop
the engine. Then, start the engine again and check
whether the ABS warning lamp or
tion lamps go out.
If the ABS warning lamp or
lamps remains lit even after the engine has been
started, we recommend you to have your vehicle
checked.
Starting and driving
and indication lamps illuminate as
and
and
4
indica-
indication
4-67