Mitsubishi MOTORS Shogun 2007 Owner's Manual page 131

1. Push the reset button (D) to view the number of months
and driving distance remaining until the next inspection.
2. Give the reset button (D) a long push (at least two sec-
onds) to make the spanner mark (A) start flashing. (If you
do not touch the reset button for 10 seconds while the
spanner mark is flashing, the display will revert to its orig-
inal indication.)
3. Give the reset button (D) a gentle push while the spanner
mark is flashing. The "-----" indication (B) will change to
"cLEAr" (C).
4. The number of months and driving distance remaining
until the next inspection will be shown.
CAUTION
!
● Daily and periodic inspections and maintenance are
your responsibility. Be sure to perform them to help
prevent accidents and breakdowns.
NOTE
● It is not possible to reset the "-----" indication (B) with the
ignition switch in the "ON" position.
● When a certain distance has been driven and a certain
period has elapsed after appearance of the "-----" indica-
tion (B), the indication is automatically reset and the
number of months until the next periodic inspection is
shown.
● If you accidentally reset the display, consult a MITSU-
BISHI MOTORS Authorized Service Point.
Fuel gauge
The fuel gauge indicates the fuel level in the fuel tank when the
ignition switch is in the "ON" position.
F- Full
E- Empty
CAUTION
!
● For petrol-powered vehicles, do not drive with an
extremely low fuel level; running out of fuel could
cause damage to the catalytic converter.
● For diesel-powered vehicles, do not drive with an
extremely low fuel level; running out of fuel could
cause damage to the fuel system.
Instruments and controls
E00500700638
3
3-7