Recall Timer Duration - Avaya IP Office Basic Edition Manual

4.8 Recall Timer Duration

Use this feature to change the length of the timed signal or switch hook flash, generated by the system Recall feature (as
well as by the Recall option used in Auto Dial and Speed Dial numbers). Recall sends this timed signal over the telephone
line to the local telephone company or PBX to which the system is connected. Typically, you use the Recall feature to
access a PBX, central office or Centrex feature, such as Call Waiting. Your local telephone company can tell you the
correct setting—for most Centrex systems, the correct setting is 800 milliseconds.
You should change the default setting only under two conditions:
·
If using the system Recall feature has no effect, lengthen the time.
·
If the system is connected to a PBX and Recall drops calls, shorten the time.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
·
To do the above during a call, you may need to press the
option. If you access phone administration during a call, only the
buttons still affect the connected call.
2. Use the up or down
Select.
3. Use the up or down
Select.
·
Alternatively, dial # and the
4. Use the up or down
5. The current setting is displayed.
6. Enter then option required between 01 and 80. Each step increases the timer by 25 milliseconds. Alternatively
use the left or right
500msec).
·
Exit programming by pressing
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press
·
If the system has a
2. The phone displays System Admin.
3. Enter two digits between 01 and 80. 01 is 25 milliseconds and 80 is 2000 milliseconds. Each number from 01 to
80 increases the timer by 25 milliseconds. Upon entry of the 2nd digit, the recall timer is updated. The default is
20 (500 milliseconds).
·
Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #107. The phone will display Recall Timer Duration.
4. Enter two digits between 01 and 80. 01 is 25 milliseconds and 80 is 2000 milliseconds. Each number from 01 to
80 increases the timer by 25 milliseconds. Upon entry of the 2nd digit, the recall timer is updated.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
Phone Based Administration
IP Office Basic Edition
arrow buttons to scroll the display to System Administration. When highlighted, press
arrow buttons to scroll the display to System Parameters. When highlighted, press
system administration
arrow buttons to scroll the display to Recall timer. When highlighted, press Select.
arrow icons to toggle the settings or Default to return to the default setting (20
PHONE. Alternatively use the Back button to move to another menu.
system password set, it is requested. Enter the password.
114
Comments on this document? infodev@avaya.com
PHONE button to display the Admin soft key
SPEAKER,
10 code.
Feature **config (ie. Feature **266344).
- Issue 6a (Thursday, February 22, 2018)
MUTE and HEADSET
Page 88