Advertisement
3. Remove final gear assembly and drive shaft.
4. Remove swing arm pivot plugs, pivot shafts
and swing arm.
D. Inspection and Lubrication
1. Remove oil seals and bearings. Inspect bearings
for pitting or other damage. Make sure that
bearings roll freely. If a bearing i s damaged,
both bearings and both sets of inner and outer
bearing races should be replaced.
NOTE: When installing new bearings, grease
liberally with lithium base, waterproof wheel
bearing grease.
2. Always replace grease seals when bearings are
removed.
3.
Examine rubber boot for damage. Replace if
damaged.
E. Installation
Installation of the swing arm can be accomplished by
reversing the removal procedure. Observe adjustment
procedures for obtaining equal
spacing.
5-8 REAR SHOCK ABSORBER
A. Removal
1. Remove one
inspect and reinstall before removing the other.
B. Inspection
Check the rod. If
1.
the shock absorber.
Check for oil leakage. If oil leakage is evident,
2.
replace the shock absorber.
3.
Operate shock absorber rod to checkdamping.
There
shock extends.
Install the shock absorber on the machine.
4.
Rear shock absorber tightening torque:
2.3~3.7
rear shock absorber a t a time,
isbentordamaged, replace
it
be no noticeable damping as
(19.6~26.8
arm
Advertisement
