Advertisement
11. To install the rear wheel, reverse the
removal procedure.
NOTE:
When installing the rear wheel, be
the splines on the wheel hub f i t into the
final gear case. Make sure there is an
enough gap between the disc pads for
the brake disc.
CA UTION:
Always use a new cotter pin when re-
assembling rear axle nut.
Axle nut:
Axle pinch bolt:
1
Rear wheel hub splines
6-2. CHARGING SYSTEM (XS750-2D Only)
A.
Charging Circuit Diagram
NOTE:
Rectifier is combined w i t h the Voltage
Requlator in the same housing.
15.0 m-kg (108 ft - lb)
0.60 m-kg (4 ft - lb)
2. Final gear case splines
Voltage Regulator with Rectifier
sure
A.C.
(PAGE 137)
C. Voltage Regulator (XS750-2D Only)
The regulator has been changed from a
mechanical-point type t o an IC(Integrated
Circuit) type. The IC Voltage Regulator is
small and normally very reliable component.
Due to i t s construction, it i s lightweight and
free from the wear and misadjustment asso-
ciated w i t h mechanical voltage regulators.
I f the following inspection reveals that the
regulator i s faulty, it cannot be adjusted and
must be replaced.
Checking IC Voltage Regulator
1. Measure the specific gravity o f the bat-
tery fluid. I f it is less than 1.26, remove
the battery and recharge until it i s more
than 1.26.
2. Remove the left
3. Check the battery terminals and couplers
for looseness.
4. Connect t w o Yamaha pocket testers to
the regulator coupler as illustrated.
CAUTION:
Beware of short-circuiting when con-
necting tester lead wires to the coupler.
Field
hand side cover.
a
Advertisement
