d. Remove the oil filter bolt and filter element.
Reinstall the drain plug (make sure
Reinstall the drain plug (make sure
e.
e.
4.0 ~ 4.5m-kg (28.9-32.5ft-lb)
f. Install the oil filter element andcover. Tighten
the oil filter bolt.
NOTE: Make sure the " 0 ' ring is positioned
properly.
g. Add oil through the dip stick hole.
Oil quantity:
Periodic Oil Change
2.8 lite r ( 3
With oil filter change:
3.2 liter (3.4
Recommended oil: except in cold weather
Yamalube 4-cycle or SAE 20W40 "SE"
(see page
8 )
istight).
istight).
it
it
US
qt)
US
qt)
h. After replacement of engine oil, and/or oil
filter, be sure t o check the oil pressure and oil
leakage. The oil pressure indicator lightshould
go of f afte r the engine
CAUTION:
If the "Oil" indicator light
remains on, immediately stop the engine.
Refer t o lubrication information in Sec.
D.
Middle Gear/Final Gear
1. Oil level measurement
a. Place the machine on a level surface and place
on the center stand. The engine should be
it
cool ( at atmospheric temperature). Allow
minutes for oil t o drain t o bottom of cases.
b. Remove the oil filler cap. Check the oil level
with level gauge (from tool kit) as shown.
The correct oil level i s between the two marks
on each end of the
gauge marked "REAR" for measuring the
rear (final) gear case. Use the end marked
NOTE: Middle gear and final gear oil can be
checked with same level gauge, which
the owners tool kit.
i s
started.
Oil
gauge. Use end of
level
measuringthe middlegear case.
3-5
2
is
in