Advertisement
(6) Final assembly
a. Install circlip on drive pinion shaft.
b. Remove housing cap screws. Clean
threads and apply thread sealant
such as "Loctite",
Remove driven pinion bearing hous-
ing screws, clean threads and apply
thread sealant. Tighten all screws to
specified torque.
Bearing Housing Screw Torque
(drive and driven pinion bearing
housings) : 2.5 m-kg (18 ft-lb)
E. Driven Pinion Reassembly
(1) Heat driven pinion bearing housing to
100°C (212°F). Install new bearing
outer
races.
and reinstall.
Outer races
(2) Install the larger bearing on driven
shaft using a press and a collar of the
proper size. Oil the bearing.
(3) Install smaller bearing inner race into
bearing housing. Oil the bearing.
(4) Install a new oil seal into the bearing
housing. Use a press if necessary.
(5) Install the washer and a new expan-
sion spacer on the driven pinion shaft.
(6) Install the driven pinion assembly into
the bearing housing assembly.
(7) Grease the inside surfaceof the bearing
housing oil seal and install the flange.
(8) Install plate washer and nut. Gradually
tighten nut to proper pre-load as fol-
lows:
a. Use a O-30 cm-kg torque wrench.
b. Hold flange and tighten nut slightly.
Avoid obertightening. Overtighten-
ing will require disassembly and
replacement
spacer.
1. Torque wrench
the expansion
of
Advertisement
