Advertisement
Take care not to allow foreign
CAUTION:
material t o enter the middle and/or final
aear case.
2.
Gear oil replacement
a. Place an oil pan under the transmission for
the middle gear and under the final gear case.
b. Remove the middle and/or final
cap(s) and the drain plug(s), and drain the oil.
not to allow foreign material to enter the
middle andlor final gear case. Do not allow
the gear oil
contact the tire and wheel.
to
c. Reinstall the middle and/or final drain plug(s).
Oil Capacity:
E. Clutch Adjustment
This model has a clutch cable length adjustor and a
clutch mechanism adjustor. The cable length adjustor5
are used to take up slack from cable stretch and to
provide sufficient free play for proper clutch operation
under various operating conditions. The clutch mech-
anism adjustor is used to provide the correct amount
of clutch "throw" for proper disengagement. Normal-
gear oil filler
ly, once the mechanism i s properly adjusted, the only
adjustment required is maintenance of free play
the clutch handle lever.
1. Free play adjustment
d. Fill the gear case(s) up to specified level.
375cc (12.7
Middle gear case:
Final gear case:
Recommended oil:
e. Reinstall the filler cap(s) securely.
NOTE: After initial 250 mile oil change,
i s normally not necessary to change middle
and final
oil more frequently than the
gear
indicated service interval of 6,000 miles.
Loosen either the handle lever adjustor lock
nut or the cable length adjustor lock nut.
Next, turn the length adjustor either in or out
until proper lever free play is achieved.
fl
U S .
02)
300cc (10.0
U.S. fl
02)
page
8 )
(see
it
at
Advertisement
