Advertisement
(5) Bearing housing outer race removal
requires an oven. Heat bearing housing
to 100°C (212°F). If necessary, tap
the races out with a punch.
(6) Large bearing (front):
Use a universal-type bearing puller to
remove the bearing from the driven
pinion.
6-2. Reassembly and Adjustment
A. Drive Pinion Assembly
(1) Install bearing into middle gear case.
(2) Install bearing into bearing housing.
(3) Install bearing inner race half onto
drive pinion shaft.
Install bearing housing onto drive
(4)
pinion. Install remaining bearing inner
race half.
Use middle gear holding tool to lock
(5)
drive pinion shaft and install nut.
Tighten to specified torque.
Drive Pinion Nut Torque:
11 m-kg (80 ft.lb)
Advertisement
