Advertisement
Clutch nut torque:
(58
8m-kg
2. Install a clutch friction plate, then a steel
clutch plate. Install clutch friction plates and
steel plates alternately.
Each steel clutch plate has a tab. There
NOTE:
is a dot on the clutch boss t o correspond t o
a
each tab. Install
clutch plate tab next t o one
dot. Position the next steel plate next t o the
ft-lbs)
I
next dot on the clutch boss. Follow this pat-
tern clockwise around the clutch boss until
al l friction and steel clutch plates are installed.
Install push rod 1 intotheslot in the main axle.
3.
4. Install plate washer onto main axle. Install
pressure plate with the arrows matching the
arrows on the clutch boss.
5. Install two clutch springs and screws lightly
so that the clutch plates can be moved.
6. Install the clutch alignment tool (special
tool) t o align the clutch friction plates. The
tool must be centered on the clutch pressure
plate.
7.
Install remaining clutch springs and screws.
Tighten all clutch screws. Remove clutch align-
ment tool. Install circlip. Install plate washer.
Clutch screw torque:
.^
0.8~1.0 m-kg (6~7 ft-lbs)
Advertisement
