3. Install oil filter. Remove oil filter filler bolt.
Fill oil filter with 0.5 lit (0.5 qt.) engine oil.
ADD OI L
H E R
CAUTION: The filter must be filled with the
specified amount of oil t o prime the oil pump
of an overhauled engine.
4. Tighten engine oil drain plug, oil filter mount-
ing bolt, and middle drain plug.
Torque:
Engine oil drain plug:
3.9~4.7 m-kg (28~34 ft-lbs)
Oil filter mounting bolt:
3.0~3.4 m-kg (22~25 ft-lbs)
Middle gear drain plug:
3.9~4.7 m-ka (28~34 ft-lbs)
5. Add oil
to engine and middle gear case
Engine oil: 3.0 lit (3.2
Middle gear oil: 360cc (12 oz)
NOTE: These oil quantities are for an over-
hauled engine. Observe oil filter filling proce-
dure.
CAUTION: If oil pressure warning light (red
light) stays on after starting engine, stop engine
immediately. Fill oil filter with oil as in step 3
above. Check for proper operation of the
warning light.
US
qt.)
NOTE: See sections
Timing plate setting.
I
3-6
on page 106
-