Advertisement
(3) Large bearing (rear): Use a universal-
type bearing puller to remove inner
race of large bearing from the drive
pinion.
(4) Use a press and the press tool No. 1
(Special Tool) to push the guide
oil seal, and roller bearing from the
main housing. Use appropriate sup-
ports for the main housing during this
operation. If undamaged, the roller
bearing may be re-used. Do not re-use
oil seal.
(5) Rear drive pinion roller bearing:
Removal of this bearing is difficult
and seldom necessary. Heat the bare
housing to 150°C (302° F). Use appro-
priately shaped punch to remove the
roller bearing outer race. Remove
inner race from the drive pinion.
7-2. Reassembly and Adjustment
A. Drive Pinion Assembly
(1) Install 2 new bearing outer races into
the drive pinion bearing housing.
(2) Install the inner race of the smaller
bearing to drive pinion shaft. Oil the
bearing.
(3) Install the inner race of the smaller
bearing into the bearing housing. Oil
the bearing.
(4) Grease a new oil seal and install it into
the bearing housing.
(5) Type 2 only: Install new expansion
spacer on the drive pinion shaft.
(6) Install the drive pinion into the driven
pinion bearing housing according to
the following types and procedures.
Advertisement
