Advertisement
8.
Remove spark plugs.
9.
Remove cylinder head holding nuts and bolts
as follows:
a. Loosen each n u t and b o l t # t u r n , observing
the torque sequence.
b. Remove the cylinder head holding nuts
first.
c. Note location of larger washers on t w o (2)
center exhaust studs.
CYLINDER
Remove cylinder head. Remove cylinder. It
10.
may be necessary t o tap each lightly w i t h a
soft hammer.
B. Cylinder Head Disassembly
Remove valve lifters and pads. Place each lifter
1.
in a box that identifies the location o f each
lifter.
HOLDING NUTS
CAUTION:
Lifters must always be installed
in their original locations.
2. Install the valve spring compressor (special
too l). Remove the valve keepers b y using a mag-
net. Remove the retainer and valve springs.
The valve springs are progressively
NOTE:
wound. The more tig htly wou nd end is placed
down against the cylinder head.
Remove valves.
3.
NOTE: Deburr any deformed valve stem end.
Use an o il stone t o smooth the stem end. This
will help prevent damage t o the valve guide
during valve removal.
Advertisement
