7.
Remove pressure plate screws and clutch
springs. Remove pressure plate.
8. Remove clutch plates, clutch push rod and
ball bearing.
9.
Use clutch holding tool (special tool) t o hold
clutch boss. Use deep 32mm socket to remove
clutch boss nut. Remove nut, spring washer,
clutch boss, plate washer, and spacer.
G. Kick Gear Removal
1.
Remove circlip holding the kick idlegear.
2.
Install the kick crank on the kick shaft. Pull
the kick starter assembly and the kick idle
gear o u t together. Remove bearing and washer.
3.
Remove the circlip holding kick gear 4. Re-
move the washer and gear.