Advertisement
2.
Install bearing cap, washers, dnd nuts. Tighten
bearing cap.
Bearing cap torque:
1.8~2.2 m-kg (13~16 ft-lbs)
Install plate washer, spring washer, and bolt
3.
holding drive axle.
4. Place shift fork guide bar into crankcase. Place
plate washer and shift forks on the guide bar.
The washer must be positioned next to the
bearing cap. Install the circlip (E-clip) on the
shaft to hold the plate washer next to the
bearing cap.
NOTE: When installing shift forks, make sure
cam follower pins are correctly positioned in
the shift
cam.
5. Install main shaft and clutch push rod
6. Install shift fork guide bar and shift fork 1.
Install circlips (E-clips).
7. Install middle driven
halves are properly installed. Each circlip half
f i t s into both crankcases.
seal.
gear. Make sure circlip
ClRCLlP
HA LF
M ID DL E
GEAR BEARING
Advertisement
