Chapter 6
Cajun Campus CLI - Layer 3
Interface Mode
ip rip rip-version Command
Use the ip rip rip-version command to specify the RIP version running on
the interface basis. Use the no form of this command to restore to the default RIP
version 1.
The syntax for this command is:
[no] ip rip rip-version [1] [2]
The possible versions of the RIP packets received and sent on an interface are:
[1]
[2]
Example:
To specify that RIP version 2 should be running on the basis of the interface
"marketing":
Router-N(config-if:marketing)# ip rip rip version 2
default-metric Command
Use the default-metric command to set the interface RIP route metric. The no
form of this command restores the default. The default metric is 1.
The syntax for this command is:
[no] default-metric <number>
number
Example:
To set the default RIP metric value. The range is 0 to 15:
Router(config-if:marketing)# default-metric 10
ip rip send-receive-mode Command
Use the ip rip send-receive-mode command to set the RIP Send and
Receive mode on an interface. The default state is talk-listen.
The syntax for this command is:
ip rip send-receive <mode>
172
RIP Version 1 packets
RIP Version 2 packets.
The interface RIP route metric value. The range is 0 to 15.
Avaya P333R-LB User's Guide