Accessing Via Mobile Client; Enable Hik-Connect Service On Camera - HIKVISION DS-2TD4668-35A4/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Confirm
Input your dial-up password again.
4. Click Save.
5. Access the device.
By Browsers
By Client Software Add the WAN dynamic IP address to the client software. Refer to the
Note
The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes
after rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a
domain name from the DDNS provider (e.g. DynDns.com). Refer to Access to Device via Domain
Name for detail information.

12.11 Accessing via Mobile Client

Hik-Connect is an application for mobile devices. Using the App, you can view live image, receive
alarm notification and so on.
Note
Hik-Connect service should be supported by the camera.

12.11.1 Enable Hik-Connect Service on Camera

Hik-Connect service should be enabled on your camera before using the service.
You can enable the service through SADP software or Web browser.
Enable Hik-Connect Service via Web Browser
Follow the following steps to enable Hik-Connect Service via Web Browser.
Before You Start
You need to activate the camera before enabling the service.
Steps
1. Access the camera via web browser.
2. Enter platform access configuration interface. Configuration → Network → Advanced Settings
→ Platform Access
3. Select Hik-Connect as the Platform Access Mode.
4. Check Enable.
Enter the WAN dynamic IP address in the browser address bar to access
the device.
client manual for details.
81