Access To Device Via Pppoe Dial Up Connection; Enable Hik-Connect Service On Camera - HIKVISION DS-2TD2137-4/P User Manual

11.7 Access to Device via PPPoE Dial Up Connection

This device supports the PPPoE auto dial-up function. The device gets a public IP address by ADSL
dial-up after the device is connected to a modem. You need to configure the PPPoE parameters of
the device.
Steps
1. Go to Configuration → Network → Basic Settings → PPPoE.
2. Check Enable PPPoE.
3. Set the PPPoE parameters.
Dynamic IP
After successful dial-up, the dynamic IP address of the WAN is displayed.
User Name
User name for dial-up network access.
Password
Password for dial-up network access.
Confirm
Input your dial-up password again.
4. Click Save.
5. Access the device.
By Browsers
By Client Software
Note
The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes
after rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a
domain name from the DDNS provider (e.g. DynDns.com). Refer to Access to Device via Domain
Name for detail information.
11.8 Enable
Hik-Connect
Hik-Connect service should be enabled on your camera before using the service.
You can enable the service through SADP software or Web browser.
Thermal Network Camera User Manual
Enter the WAN dynamic IP address in the browser address bar to
access the device.
Add the WAN dynamic IP address to the client software. Refer to the
client manual for details.
Service on Camera
59