Table of Contents
Advertisement
9.4 Set SNMP
You can set the SNMP network management protocol to get the alarm event and exception
messages in network transmission.
Before You Start
Download the SNMP software and manage to receive the device information via SNMP port.
Steps
1. Go to Configuration → Network → Network Parameters → SNMP.
2. Check Enable SNMPv1/Enable SNMP v2c/Enable SNMPv3.
Note
● The SNMP version you select should be the same as that of the SNMP software.
● Use different versions according to the security levels required. SNMP v1 is not secure and
SNMP v2 requires password for access. SNMP v3 provides encryption and if you use the third
version, HTTPS protocol must be enabled.
3. Set the SNMP parameters.
4. Click Save.
9.5 Set Port
The device port can be modified when the device cannot access the network due to port conflicts.
Go to Configuration → Network → Network Parameters → Port for port settings.
Tyre and Axle Recognition Unit User Manual
43
Advertisement
Table of Contents
