Snmp; Set Srtp; Port Mapping - HIKVISION DS-2XS6A87G1-LS/4G User Manual

7.2 SNMP

You can set the SNMP (Simple Network Management Protocol) to get device information in
network management.
Before You Start
Before setting the SNMP, you should download the SNMP software and manage to receive the
device information via SNMP port.
Steps
1. Go to Configuration → Network → Advanced Settings → SNMP .
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP software.
And you also need to use the different version according to the security level required. SNMP v1
is not secure and SNMP v2 requires password for access. And SNMP v3 provides encryption and
if you use the third version, HTTPS protocol must be enabled.
3. Configure the SNMP settings.
4. Click Save.

7.3 Set SRTP

The Secure Real-time Transport Protocol (SRTP) is a Real-time Transport Protocol (RTP) internet
protocol, intended to provide encryption, message authentication and integrity, and replay attack
protection to the RTP data in both unicast and multicast applications.
Steps
1. Go to Configuration → Network → Advanced Settings → SRTP .
2. Select Server Certificate.
3. Select Encrypted Algorithm.
4. Click Save.
Note
Only certain device models support this function.
●
If the function is abnormal, check if the selected certificate is abnormal in certificate
●
management.

7.4 Port Mapping

By setting port mapping, you can access devices through the specified port.
Network Camera User Manual
51