SMC Networks EX245-FPS1 Operation Manual page 95

Table of Contents

Advertisement

Code
Additional Information
0x01F3
None
499dez
0x01F4
None
500dez
0x01F5
None
501dez
0x01FD
None
509dez
0x01FE
None
510dez
Brief Description
The allocation of the diagnostic and activation
Error caused by
variables on the acknowledgement module should
receiving an
be checked.
unexpected message
The device firmware handles this diagnostic
for the
message with the highest priority. It is not until this
acknowledgement of
is correctly acknowledged that other errors, if
diagnostic messages.
present, are notified.
Error caused by
receiving an
At least one reserved bit in the process data image
unexpected value
was set. The process data allocation should be
regarding the process
checked.
data image. All outputs
The acknowledgement deletes the message and
are switched off
releases all outputs.
immediately.
By acknowledging one of the following diagnostic
The time between two
messages 0x021X, 0x025X, 0x026X, 0x028X,
restarts of the outputs
0x029X, 0x02AX or 0x02EX, provided there are no
is too short – the time
other relevant error messages, a restart of the
interval must be at
outputs can be triggered. The repetition of this
least 30 seconds.
process is only possible after a waiting time.
The process image for parameter values must
Only applies to Safety
contain valid values.
Mode (Module
The SI unit needs a HW reset when the process
Passivation/xxx)
image contains new parameter values.
The SI unit received
Hardware reset can be performed by downloading
an invalid process
a project to the PLC using the configuration
image for the
software and resetting the power supply of the SI
parameter values.
unit.
The start-up mode
The acknowledgement deletes the message.
(CM) was activated.
- 94 -
Solution
No.EX##-OMY0004

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX245-FPS1 and is the answer not in the manual?

This manual is also suitable for:

Ex245-fps2Ex245-fps3Ex245-dx1Ex245-dy1

Table of Contents