Appendix D: Diagnostic Messages For Parameter Errors For Profisafe - SMC Networks EX245-FPS1 Operation Manual

20. Appendix D: Diagnostic messages for parameter errors for PROFIsafe

Error code
dec hex
The parameterized F_Destination_Address does
64 40 not match the PROFIsafe address set on the
module (F-Module).
Invalid parameterization of
F_Destination_Address.
65 41
Addresses 0000
permitted.
Invalid parameterization of F_Source_Address.
66 42 Addresses 0000
permitted.
Invalid parameterization of F_WD_Time.
67 43
A monitoring time of 0 ms is not permitted.
Invalid parameterization of F_SIL.
68 44 The safety module (F-Module) cannot support the
required SIL.
Invalid parameterization of F_CRC_Length.
69 45 The CRC length generated by the safety module
(F-Module) does not match the required length.
Invalid F_Parameter record version.
70 46 The safety module (F-Module) version does not
match the required version.
The checksum determined by the safety module
(F-Module) via the PROFIsafe parameters
71 47
(CRC1) does not match the CRC1 transmitted in
the parameter telegram.
72 48 Device-specific diagnostics.
73 49 Save i-Parameter watchdog time exceeded.
74 4A Restore i-Parameter watchdog time exceeded.
75 4B Invalid S_iParCRC.
76 4C F_Block_ID is not supported.
77 4D Reserved.
78 4E Reserved.
79 4F Non-specified (unknown) error.
AddValue (hex)
03F2
03FD
Table 21-1 F-Parameter parameter errors
Error cause
and FFFF are not
hex hex
and FFFF are not
hex hex
Table 21-2 i-Parameter parameter errors
Error cause
iPar_CRC is incorrect.
PST_Device_ID is incorrect.
- 104 -
Remedy
Make sure that the PROFIsafe address of the
module and the value in F_Destination_Address
are the same.
Correct value.
Correct value.
Correct value.
Use a module with the required SIL.
The safety module achieves SIL 3, maximum.
Check device description.
Check device description.
Only V2 mode permitted.
Check F-Parameters. Repeat calculation.
Correct value.
Check device description.
Remedy
Check i-Parameters. Repeat calculation.
Contact SMC
No.EX##-OMY0004