Led Status Indicators - B&R Automation PC 2200 User Manual

Technical data

2.2.6.9 LED status indicators

The LED status indicators are located between the power button and Ethernet 2 interface.
The following intervals are used for the LED status indicators:
Width of box: 250 ms
Repeat interval: 500 ms. 2 boxes thus correspond to one interval.
LED Color Status
Power Green On
Blinking
Red On
Blinking
Red-Green Blinking
Disk Yellow On
(CFast)
Link Yellow On
Blinking
Run Green Blinking
Green On
Red On
Orange Blinking
44
Explanation
Power supply OK
The device is started up; the battery state is "BAD".
Information:
For additional information,
ment".
The system is in power saving (standby) mode (S5: soft-off
mode or S4: hibernation/suspend-to-disk mode).
The MTCX is running; the battery state is "BAD". The system is
in power saving (standby) mode (S5: soft-off mode or S4: hiber-
nation/suspend-to-disk mode).
Faulty or incomplete BIOS, MTCX or I/O FPGA update, power
supply OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, pow-
er saving (standby) mode (S5: soft-off mode or S4: hiberna-
tion/suspend-to-disk mode)
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
state BAD, power supply OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
state BAD, power saving (standby) mode (S5: soft-off mode or
S4: hibernate/suspend-to-disk mode)
Information:
An update must be performed again.
Indicates CFast access.
Indicates an active SDL connection on the panel connector.
An active SDL connection was interrupted due to power loss of
the panel.
Information:
Check the power supply or power connection of the
connected panel.
Automation Runtime is starting up.
Controlled by Automation Runtime (ARemb and ARwin).
Application running
Controlled by Automation Runtime (ARemb and ARwin).
Application in service mode
Controlled by Automation Runtime (ARemb and ARwin).
A license violation has occurred.
Table 30: LED status indicators - Data
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
LED "RUN"
LED "Link"
LED "Disk" (CFast)
LED "Power"
see "Battery compart-
LED indicator